Troubleshooting - Black and Decker ST4500 Manual De Instrucciones

c. Holding the line in the gap,
insert the end through the
eyelet in the hub and slip the
spool into the hub, as shown
in figure 13.
Make sure the spring is still
in place in the hub. If the
spool does not slip into the
hub easily, press gently and
pull straight out on the cutting
line that protrudes through
the eyelet.
4. Once the spool drops into the
hub, align the release tabs on
the shroud with the slots in the
hub as shown in figure 14 and
press the shroud into place.
Be sure that both release tabs
snap into place.
5. To replace the line on a spool,
follow the steps below
a. Locate, on the empty
spool, one of the two small
holes shown in figure 15.
13
14
15
b. Insert the end of the line no
more than 1/8 in. into the hole
and begin winding the line
around the spool (figure 16).
Be sure to wind the line in
the direction of the arrow
in figure 17. Do not overfill
spool. The spool holds 20
feet (6 m) of line.
c. Perform steps 3 and 4
above.
Problem Possible Cause
•Unit will not start. • Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker
is tripped.
• Cord or switch is
damaged.
For assistance with your product, visit our website www.blackanddecker.
com for the location of the service center nearest you or call the
BLACK+DECKER help line at 1-800-544-6986.
7
16
17

Troubleshooting

Possible Solution
• Plug in cord.
• Replace circuit fuse.
• Reset circuit breaker.
• Have cord or switch
replaced at
BLACK+DECKER
Service Center or
Authorized Servicer.