Nice E MAT MO 517 Instrucciones Y Advertencias De Instalación Y Uso página 6

B - Manual adjustment of upper limit switch height ("0") and lower height ("1")
Warnings:
• This procedure overwrites previously adjusted heights with the new heights using this same procedure.
• Every time the motor is powered, 2 movements are performed if at least one transmitter and the limit switch heights are not in the memory.
• If your shutter is fitted with a hook and slats, all of which tilt at the same time, Up limit "0" must be located above the tilt mechanism (i.e. beyond
point "F"), whereas DOWN limit "1" must be below the mechanism (i.e. before point "A"). For information on the mechanism, refer to par. C.1.
B.1 - To adjust the UPPER limit switch ("0")
Before starting the procedure, bring the rolling shutter to the midpoint of its stroke.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the n key pressed again and wait for the motor to perform 4 movements. Upon completion, release the key.
03. Keep the s key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
04. Adjustment of height: Keep the s (or t) key pressed until the shutter reaches the desired "0" height. Note – to adjust the height with precision, press the s
and t several times consecutively (at each pulse theshutter moves a few millimeters.
05. Keep the n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
01
5
sec.
04
Note – During the procedure, you can abort the program at any time, by allowing 30 seconds to elapse between key presses.
B.2 - To adjust the LOWER limit switch ("1")
Before starting the procedure, bring the rolling shutter to the midpoint of its stroke.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the n key pressed again and wait for the motor to perform 4 movements. Upon completion, release the key.
03. Keep the t key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
04. Adjustment of height: Keep the t (or s) key pressed until the shutter reaches the desired "1" height. Note – to adjust the height with precision, press the s
and t several times consecutively (at each pulse theshutter moves a few millimeters.
05. Keep the n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
01
5
sec.
04
Notes • During the procedure, you can abort the program at any time, by allowing 30 seconds to elapse between key presses. • After the adjustments, the s key will
command the Raising motion and the key t key will command the Lowering motion. The shutter will move within the limits constituted by the two limit switch heights.
6 – English
02
2
"0"
02
2
"1"
4
5
sec.
05
"0"
fine adjustment
fine adjustment
4
5
sec.
05
"1"
fine adjustment
fine adjustment
03
2
5
sec.
3
5
sec.
03
2
5
sec.
3
5
sec.