Tabla de contenido
Idiomas disponibles
Idiomas disponibles
other condition that may affect the power tools
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
f.
Keep cutting tools sharp and clean. Properly maintained
cutting tools with sharp cutting edges are less likely to
bind and are easier to control.
5. Service
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
6. Electrical safety
Your tool is double insulated; therefore no earth wire
is required. Always check that the main voltage
corresponds to the voltage on the rating plate.
Warning! If the power cord is damaged, it must be
replaced by the manufacturer, authorized
Black & Decker Service Center or an equally qualified
person in order to avoid damage or injury. If the power
cord is replaced by an equally qualified person, but
not authorized by Black & Decker, the warranty will
not be valid.
7. Labels on tool
The label on your tool may include the following symbols:
Read Instructions Manual
Use Eye Protection
Use Ear Protection
V ........... Volts
A ........... Amperes
Hz ......... Hertz
W........... Watts
min........ minutes
ADDITIONAL SAFETY INSTRUCTIONS
FOR ANGLE GRINDERS
Do not cut or grind light metal with a magnesium content
exceeding 80%, since this type of metal is flammable.
Only use grinding and cutting discs and other accessories
recommended in this manual.
Make sure that the maximum speed of the grinding or
cutting disc exceeds the no-load speed of the tool.
Do not cut workpieces requiring a maximum depth of cut
exceeding that of the cutting disc.
........ Alternating Current
........ Direct Current
n
.......... No-Load Speed
0
........ Class II Construction
........ Earthing Terminal
........ Safety Alert Symbol
.../min.... Revolutions or
Reciprocation
per minute
Never use the tool without the guard, except for sanding.
Do not exert side pressure on the grinding or cutting disc.
Use this tool only as a hand held tool.
Sanding
Wear a dust mask whenever sanding.
Thoroughly remove all dust after sanding.
Take special care when sanding paint which is possibly
lead based or when sanding some woods and metal which
may produce toxic dust:
-
Wear a dust mask specifically designed for protection
against lead paint dust and fumes and ensure that
persons within or entering the work area are also
protected.
-
Do not let children or pregnant women enter the work
area.
-
Do not eat, drink or smoke in the work area.
-
Dispose of dust particles and any other debris safely.
FEATURES
1. Angle grinder
2. Side handle
3. Grinding or cutting disc
4. Flange set
5. Two-pin spanner
6. Instruction manual
Overview (fig. A)
1. On/off switch
2. Side handle
3. Spindle lock
4. Guard
5. Grinding or cutting disc
ASSEMBLY
Warning! Before attempting any of the following operations,
make sure that the tool is switched off and unplugged and that
the disc has stopped rotating.
Removing and refitting of the guard
Warning! Never use the tool without the guard, except
when sanding.
Removing (fig. B)
This tool is fitted with a guard. For sanding only, you can re-
move the guard as follows.
Remove the outer flange, disc and inner flange as described
below.
Use a screwdriver to remove the screws (6).
Remove the flange (7), guard (4) and spring washer (8).
Store these parts carefully.
Refitting (fig. C)
Place the tool on a table, with the spindle (9) facing up.
15
ENGLISH
Tabla de contenido
