TurboChef TDO30 Serie Instrucciones De Instalación página 3

4-wire hook up
figure 4: 4-wire (left) and 3-wire (right) hook ups.
7. Place the oven into the cabinet.
o
The oven weighs approximately 410 lbs. (186 kg.) It requires 2 or more individuals to lift it.
warnIng:
DO NOT push on the outer frame. Doing so could cause the door(s) to misalign, requiring
warnIng:
repair and/or replacement.
When the unit is lifted into the cabinet opening, the installer will need to remove the support rails
noTe:
to allow the oven to slide into the opening properly. Remove each support rail by unscrewing the support screw
on either side of the rail. Supports should then slide off the oven base.
8. Secure the oven to the cabinets.
o
Open the top oven door. Making sure the oven is fully installed against the front of the cabinet, install the two (2)
screws supplied with the oven through the side trim holes on either side. Screws should engage the inner cabinet
and secure the oven in place. See Figure 3 on page 1.
9. Reconnect power to the breaker.
o
10. Verify the oven is functional and set the clock.
o
(A) Advance the CookWheel
should appear. Once this is verified, return CookWheel to the "Off" position.
DO NOT attempt to program any cook programs in the top oven during installation. Removal of
noTe:
literature and operation of the top oven should be performed only by the consumer.
(B) Verify all packing material is removed from the lower oven cavity. Select "Bake" on the Oven Mode Dial.
Using the Temperature Dial, set the temperature. Verify oven begins heating. Once verified, return Oven Mode
Dial to the "Off" position.
(C) Set clock on the top oven. Press the Set Clock Knob (top knob next to the clock). Knob will pop out. Turn knob
left or right to set correct time. When time is set, press knob back into its original position.
on the top oven to "Bake". The display should illuminate and the TurboChef logo
TM
3-wire hook up
3