Group Control; Setting The "My" Favourite Light Intensity - SOMFY RTS-LB1 Manual De Instrucciones

Lighting Mod/Var Ramp RTS-LB1
1) Press the PROG button on the programmed control point (A) until
the ramp comes on then goes out: the Lighting Mod/Var Ramp
RTS-LB1 will be in programming mode for 2 minutes.
2) Briefl y press the PROG button on the RTS control point (B) to be
added: the ramp comes on then goes out; the RTS control point has
been added.
- Repeat these two steps to add each RTS control point.

7.2.2 Group control

Group control: an RTS control point controls several Lighting Mod/Var
Ramp RTS-LB1 units.
1) Switch off the power supply to the Lighting Mod/Var Ramp RTS-LB1
(C, D and E) to be controlled by a single control point.
2) Switch on the power supply to the fi rst Lighting Mod/Var Ramp
RTS-LB1 (C) to be linked to the control point.
3) Simultaneously press the Up/Down buttons on the RTS control point:
the ramp comes on then goes out.
4) Press the PROG button on the RTS control point: the ramp will come
on then go out again to indicate that the RTS control point has been
programmed into the Lighting Mod/Var Ramp RTS-LB1.
- Switch off the power supply to the newly linked Lighting Mod/Var
Ramp RTS-LB1 before adding the next Lighting Mod/Var Ramp
RTS-LB1.
- Switch on the power supply to another Lighting Mod/Var Ramp
RTS-LB1 to be linked and repeat steps 3) and 4)
- Repeat the procedure for each of the other Lighting Mod/Var Ramp RTS-LB1 units to be controlled
with this RTS control point.
- Switch on the power supply to all the Lighting Mod/Var Ramp RTS-LB1 units linked to the RTS
control point.

7.3 Setting the "my" favourite light intensity

N.B.: The favourite light intensity factory setting for the Lighting Mod/
Var Ramp RTS-LB1 is 50% of the maximum intensity. This favourite
position may be modifi ed as required.
7.3.1 From a Mod/Var range control point
A Mod/Var range point is a control point which has an adjustment
thumbwheel.
1) Press the my button to switch on the ramp to the preset favourite
position.
2) Move the thumbwheel to adjust the light intensity level as
required.
3) Once the required level of light intensity has been reached, press
the my button until the ramp comes on then goes out:
- The new favourite light intensity level has been programmed and
the ramp will come on at this level.
38 Copyright © 2008 - 2010 Somfy SAS. All rights reserved.
Installation guide
+
1 2
A B
PROG PROG
2 min.
+
1 2
A B
PROG PROG
2 min.
1 OFF
C D E
2 3
C
ON
C
4
C
C
PROG
1
+
2
100%
-
0%
3