Commissioning; Programming An Rts Control Point; Operation; With A Mod/Var Range Rts Control Point - SOMFY RTS-LB1 Manual De Instrucciones

Lighting Mod/Var Ramp RTS-LB1

5. Commissioning

5.1 Programming an RTS control point

The Lighting Mod/Var Ramp RTS-LB1 is commissioned using an RTS
control point.
Caution! If the installation comprises several Lighting Mod/Var Ramp
RTS-LB1 units, only one Lighting Mod/Var Ramp RTS-LB1 should be
connected at a time!
1) Press the up and down buttons on the RTS control point simultaneously
until the ramp comes on then goes out.
2) Briefl y press the PROG button on the RTS control point: the ramp
will come on then go out again to indicate that the RTS control point
has been programmed into the Lighting Mod/Var Ramp RTS-LB1.

6. Operation.

6.1 With a Mod/Var range RTS control point

1) To switch the light on:
- Press the Up button.
2) To switch the light off:
- Press the Down button.
3) To switch the light on directly to the "my" preset favourite
light intensity setting
- Press the my button.
4) To increase the light intensity
- Move the thumbwheel up:
- The light intensity begins on the minimum light intensity level
possible, i.e. on a night-light level;
- The light intensity increases every time the thumbwheel is
moved.
5) To decrease the light intensity
- Move the thumbwheel down:
- The light intensity decreases every time the thumbwheel is
moved;
- The minimum light intensity corresponds to a "night-light" level.
Note: Once the "night-light" level has been reached, move the
thumbwheel down to switch off the ramp.

6.2 With an RTS control point

6.2.1 Standard control point
N.B.: A standard control point is a three button control point (Up/
Stop-my/Down).
1) To switch the light on:
- Briefl y press the Up button.
2) To switch the light off:
- Briefl y press the Down button.
3) To switch the light on directly to the "my" preset favourite
light intensity setting
- Press the my button.
4) To increase the light intensity
- Press and hold the Up button:
- The light intensity increases as long as the button is held.
- Release the Up button when the required light intensity is
reached.
36 Copyright © 2008 - 2010 Somfy SAS. All rights reserved.
Installation guide
1
2
PROG.
1
ON
2
OFF
3
my
+
4
100%
-
0%
+
5
100%
-
0%
1
ON
2
OFF
3
my
+
4
100%
-
0%