Tabla de contenido
Idiomas disponibles
Idiomas disponibles
BURNER FLAME PATTERN
dark or have an orange/reddish tinge.
the log cures.
• turn heater off (see To Turn Off Gas to Appliance, page 20).
• see Troubleshooting, page 23-25.
Fig. 22 - Correct Burner Flame Pattern
WARNING: Turn off heater and let cool before servicing.
CAUTION: You must keep control areas, burner, and circulating air passageways of heater
clean. Inspect these areas of heater before each use. Have heater inspected yearly by a
from carpeting, bedding material, pet hair, etc.
WARNING: Failure to keep the primary air opening(s) of the burner(s) clean may result in sooting
and property damage.
BURNER ORIFICE HOLDER AND PILOT AIR INLET HOLE
The primary air inlet holes allow the proper amount of air to mix with the gas. This provides a clean
each heating season. Blocked air holes will create soot. We recommend that you clean the unit every
service person.
We also recommend that you keep the burner tube and pilot assembly clean and free of dust and dirt.
To clean these parts we recommend using compressed air no greater than 30 PSI. Your local
computer store, hardware store or home center may carry compressed air in a can. If using
compressed air in a can, please follow the directions on the can. If you don't follow directions on the
can, you could damage the pilot assembly.
2-3 inches
above logs
Fig. 23 - Incorrect Burner Flame
21
6-12 inches
above logs
Pattern
Tabla de contenido
