Using Your Mask - ResMed Mirage FX Guia Del Usuario

•
Oxygen supports combustion. Oxygen must not be used while
smoking or in the presence of an open flame. Only use oxygen
in well ventilated rooms.

Using your mask

When using your mask with ResMed CPAP or bilevel devices that
have mask setting options, refer to the Technical specifications section
in this user guide for mask setting options.
For a full list of compatible devices for this mask, see the Mask/
Device Compatibility List on www.resmed.com on the Products page
under Service & Support. If you do not have internet access, please
contact your ResMed representative.
Note: If you experience nasal dryness or irritation, using a humidifier
is recommended.
Fitting
The fitting illustrations section in this user guide show the sequence
for obtaining the best fit and comfort when using your mask.
Fitting steps
Prior to fitting your mask, remove the elbow from the mask by
pressing the side tabs. Connect the elbow to your device air tubing.
1. With both lower headgear straps released, hold the mask
against your face and pull the headgear over your head.
2. Bringing the lower straps below your ears, loop the headgear
into the lower hooks on the mask frame.
3. Unfasten the Velcro
until they are comfortable and reattach the Velcro. Do not
overtighten.
4. Repeat step 3 with the lower headgear straps.
5. Attach the combined elbow assembly and air tubing to the
mask by pressing the side-tabs and pushing into mask frame.
6. Your mask and headgear should be positioned as shown.
Ensure the headgear label is facing outwards.
, pull the upper headgear straps evenly
®
2