Start Up - American Hometec AHQ-TC10 Manual De Instalación Y Funcionamiento

Start Up

1. Open water inlet and outlet. Turn on water and let water flow through
unit forone to two minutes and double check to ensure there are no
leaks. CAUTION:DO NOT OPERATE UNIT DRY.
2. If no leaks are found, turn on the power to unit at breaker.
3. Turn on the water heater power switch located on the control panel on
the frontof the unit.
FOR REFERENCE: Temperature for bathroom sink is typically set to 98
kitchen istypically set to 110
However, temperature should not exceed the highest temperature due to
possibility of scalding.
4.
Menue navigation/Set temperature to display Celsius or Farenheit.
6. Set the desired water temperature by pressing power level "UP" or
"DOWN" button on the control panel. Turn the hot water faucet on all
the way and let the initial cold water in the pipe run out, you will get the
F / 43 C. Adjust temperature to
o o
LED display shows actual outlet water temperature,Factory
Default Temperature is 104℉
Light on showsheating
Light on showspower on
UP and DOWN buttons for adjusting water temperature1℃(1℉)
by up or down each time. The temperature will increase/Decrease
4 times per second when holding 2 seconds. To lock the
temperature set, hold both UP and DOWN buttons down for 3
seconds till LED display showing "Lc" indicating lock function on.
Release both buttons. The LED display will show "Lc" and current
water temperature, temperature set alternately every 1 second.
To unlock temperature setting, hold both UP and DOWN buttons
for 1 second. If the inlet water temperature is 3℃ higher than the
setting water temperature, it will stop the water heating and
show "H" on the LED display.
POWER button for turning heater on or off.If the heater will not be
in use for a long time (such asduring vacation), this POWER button is
recommended to beturned off.Holding the button 5 seconds and
more can switching between ℃/℉display.
11
F / 37 C and for
o o
meet your comfort needs.