Scott MHLM 16 Manual Del Usuario página 6

RETENTION SYSTEM CHECK
Fasten the chin strap such that it is as tight as possible without
choking. There should be no slack and the strap should fit snug-
ly under the chin. Place your hand on top of the helmet (see dia-
gram 3) and attempt to push the helmet off by rolling it forward.
Next, place your hand on the chin bar and attempt to push the
helmet off by rotating it towards the rear. If in either case, the
helmet is able to come off your head, do not use this helmet and
find a better fitting size, or check that the chin strap is securely
fastened. These steps should be repeated until you are able to find the right size hel-
met for you.
CORRECT FITTING
Make sure that the helmet fits correctly as shown below, the helmet must NOT be too
low or high on the head because it will interfere with your line of sight. Eyes should be
central to the eye aperture. Please note that the visor found in our off-road helmets is
adjustable. Try the off-road helmet with the visor in all positions prior to purchase in
order to satisfy yourself that the helmet meets your requirements. SCOTT Sports SA
shall not be liable for any damages and losses due to incorrect fitting.
• IV. VISOR REMOVAL AND ADJUSTMENT
Remove the two side screws and washers from the visor. Remove the central screw
located underneath the visor. To replace the visor, reverse the mentioned process.
Avoid damage to the visor by over tightening the screws. Use the central screw to lock
the visor in your favored position. If in doubt about maintenance or how to remove
or replace parts of your helmet, please see your local dealer. DO NOT MAKE ANY
CHANGES OR MODIFICATIONS TO YOUR HELMET OTHER THAN THOSE SPECI-
FIED BY THE MANUFACTURER, AS THIS COULD SERIOUSLY REDUCE THE PERFOR-
MANCE AND SAFETY OF YOUR HELMET. SCOTT Sports SA shall not be liable for any
damages and losses due to any improper changes or modifications.
ENGLISH - 6