Kenmore 415.23665310 Manual De Uso página 13

Side burner Ignitor Lighting
Do not lean over grill while lighting.
1. Open side burner lid. Turn ON gas at LP cylinder.
2. Turn side burner knob to the HI position, push and hold
ELECTRONIC IGNITOR button.
3. If side burner does NOT light within 5 seconds, turn knob
to OFF, wait 5 minutes, then repeat lighting procedure.
Match lighting the Side Burner - Figure D
1. Open the side burner lid during lighting.
2. Place match in match holder. Strike the Match. Position
lit match close to the side burner.
3. Push in and turn side burner knob to
burner lights and stays lit.
4. If ignition does NOT occur in 5 seconds, turn the burner
control knob OFF, wait 5 minutes for gas to clear away,
and repeat the lighting procedure.
Figure D
Outdoor Oven Ignitor Lighting
Do not lean over grill while lighting.
1. Open Oven lid. Turn ON gas at LP cylinder.
2. Turn Oven knob to the
ELECTRONIC IGNITION button.
3. If oven burner does NOT light within 5 seconds, turn knob to
OFF, wait 5 minutes, then
repeat lighting procedure.
Outdoor Oven Match Lighting
1. Open Oven lid. Turn ON
gas at LP cylinder.
2. Place match into match holder
(hanging from side panel of grill).
Light match; then light burner by
placing match through the match
light hole on left side of oven.
3. Turn oven knob to the
Be sure burner lights and stays lit.
position. Be sure
position, push and hold
position.
Burner Flame Check
• Remove cooking grates and flame tamers. Light burners,
rotate knobs from HIGH
smaller flame in low position than seen on HIGH
Perform burner flame check on side burner, searing
burner and rotisserie also. Always check flame prior to
each use. If only low flame is seen refer to "Sudden drop
or low flame" in the Troubleshooting Section.
Turning Grill Off
• Turn all knobs to OFF position. Turn LP cylinder off by
turning hand-wheel clockwise to a full stop.
Ignitor Check
• Turn gas off at LP cylinder. Push and turn control knob
to and hold in. You will hear a clicking sound as the
burner is being ignited. Ignition should occur within 5
seconds, but continue to hold the knob in for a full 10
seconds to maintain ignition.
Valve Check
• Important: Make sure gas is off at LP cylinder before
checking valves. Knobs lock in OFF position. To check
valves, first push in knobs and release, knobs should
spring back. If knobs do not spring back, replace valve
assembly before using grill. Turn knobs to LOW position
then turn back to OFF position. Valves should turn
smoothly.
Hose Check
• Before each use, check to see if hoses are cut or worn.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified by manufacturer.
General Grill Cleaning
• Do not mistake brown or black accumulation of grease
and smoke for paint. Interiors of gas grills are not
painted at the factory (and should never be painted).
Apply a strong solution of detergent and water or use a
grill cleaner with scrub brush on insides of grill lid and
bottom. Rinse and allow to completely air dry. Do not
apply a caustic grill/oven cleaner to painted or glass
surfaces.
• Plastic parts: Wash with warm soapy water and wipe
dry.Do not use citrisol, abrasive cleaners, degreasers or a
concentrated grill cleaner on plastic parts. Damage to
and failure of parts can result.
• Porcelain surfaces: Because of glass-like composition,
most residue can be wiped away with baking
soda/water solution or specially formulated cleaner. Use
nonabrasive scouring powder for stubborn stains.
• Painted surfaces: Wash with mild detergent or
nonabrasive cleaner and warm soapy water. Wipe dry
with a soft nonabrasive cloth.
• Stainless steel surfaces: To maintain your grill's high
quality appearance, wash with mild detergent and warm
soapy water and wipe dry with a soft cloth after each
use. Baked-on grease deposits may require the use of an
abrasive plastic cleaning pad. Use only in direction of
brushed finish to avoid damage. Do not use abrasive
pad on areas with graphics.
• Cooking surfaces: If a bristle brush is used to clean any
of the grill cooking surfaces, ensure no loose bristles
remain on cooking surfaces prior to grilling. It is not
recommended to clean cooking surfaces while grill is hot.
to low. You should see a
HIGH
LOW
464225913 • 13