Best WC26I Manual De Usuario página 8

INSTALL THE DUCTWORK
DUCTED HOODS ONLY
CAUTION: To reduce the risk of fire, use
only metal ductwork.
1. Decide where the ductwork will run
between the hood and the outside.
2. A straight, short duct run will allow the hood
to perform most efficiently.
3. Long duct runs, elbows, and transitions
will reduce the performance of the hood.
Use as few of them as possible. Larger
ducting may be required for best
performance with longer duct runs.
4. Install a roof or wall cap. Connect round
metal ductwork to cap and work back to-
wards hood location. Use duct tape to seal
the joints between ductwork sections.
INSTALL ELECTRICAL
DUCTED and NON-DUCTED HOODS
WARNING : Electrical wiring must be
done by a qualified person(s) in
accordance with all applicable codes and
standards. This range hood must be
properly grounded. Turn off electrical
power at service entrance before wiring.
1. Plan where the hood will be located above
the cook top. Refer to the "INSTALL
MOUNTING BRACKET" section for hood
mounting height options. Fig. 6.
2. Install a standard 2" x 4" wall outlet box
and 3-blade 125 volt, 15 Amp grounded
receptacle.
3. Mount the 11-1/2" below the finished
ceiling.
4. Locate the box and the receptacle within
boundary shown and off center of the
ductwork (to allow for power cord plug and
flue clearance).
ROOF CAP
DECORATIVE
FLUE
HOOD
22" TO 28" ABOVE
COOKING SURFACE
(see "INSTALL
MOUNTING BRACKETS"
section for mounting
restrictions
CENTER
OF THE
HOOD
- 8 -
6"
ROUND DUCT
WALL
CAP
ROUND
ELBOW
6"
ADAPTER
FIG. 5
8"
4" 11-1/2"
CORNER
OF
FINISHED
CEILING
FIG. 6