lamber DSP26-ADD Manual Del Usuario página 19

NOTE. STOP CYCLE function: the washing cycle can
be stopped if you push again the cycle pushbutton "B"
(light "C" flashing now) :
to restarting washing cycl push again button "B".
WARNING! Do not open the dishwasher door
durino the washing cycle.
Manuel self-cleaning cycle:
- Ensure that the tank is empty,
- Make sure that the machine is switched off
- Remove the overflowpipe from the tank
- Close the door of the diswasher
- Press button "A" to switch the machine on
- Self-cleaning cy cle starts, y ou can stop it after 5
minutes, otherwise self-cleaning cy
automatically turn off after 10 minutes. (for Machine
with drain pump the tank fills w
when maximum level is r
manually and repeat the operation if needed).
In case of accidental opening the cy cle stops. If You
close the door, the cy cle st arts again from the point
where it had stopped.
At the end of the cycle open the door and pull out the
basket.
ACHIEVEMENTS
Any deficiency in the w ashing process is apparent
when dirty residuals are visible. Any halos might be
caused by an insuffucuent rinsing: in this case, check
that the rinsing jets are clean and there is a sufficient
pressure in the water distribution network.
In the case that residuals are present, check that:
• the washing jets are clean
• there is detergent
• the pump suction filter is clean
• the positions of the objects in the rack are correct.
SALT CONTROL
(for machines with Water softener)
If the glass-w asher is equipped w ith a W ater softener
the regeneration of resins is automatic according to
parameters fixed by the producer.
According to the water hardness, it is possibile to
modify the programming of the regeneration.
N.B. each 90 seconds
duration, the machine stops for about 2
minutes to carry out the regeneration.
See the corresponding table in the installer section.
When it is necessary to add salt in the container, the
green lamp "H" lights up.
Unscrew the plug of the salt container at the bottom of
the tank and put 1 kg coarse salt tablets in it. Clean the
gasket and screw the plug.
Attention!
The lack of salt in the c ontainer damages the machine
because of limestone, besides a defective w ashing of
glasses and dishes.
These damages are not covered by the warranty.
cle w ill
ith w ater and stops
eached: empty the tank
of tank filling
DISHES POSITIONING
It is suitable to place dishes,
basket with the concave side facing
Place mixed cutlery in a vertical position into the suitable container minding not to cram them and
whit handgrips towards the bottom (see draw).
It is suitable to place glasses, inside the plastic
basket with the concave side towards the
bottom. Place mixed cutlery in a vertical position
into the suitable container minding not to cram
them and with hafts towards the
draw).
RINSING ADDITIVES
To grant a perfect rinsing, a quick drying and to
avoid calcareous sediments on glasses
cups you must add a surfactant on water
(Brightener).
Your cleansing agent supplier will be able to
suggest the most suitable product. Your
machine is equipped with a rinse aid dispenser.
Mean concentration used is 0,15 g/lt.
DRAIN PUMP INSTRUCTION
(only for machines with drain pump)
The drain pump starts up automatically just
during the washing cycle to discharge
exceeding water coming from the rinsing cycle.
At the end of the working day, in order to
completely discharge the tank, it is necessary
to perform the following operations:
1. Open the door of the dishwasher
2. Remove the overflow pipe from the tank;
3 Keep the pushbuttons
tank is empty.
Reinstall the flow over and shut the door.
19
inside the plastic
upwards.
bottom (see
and
the
"B" pressed until the