Adjust The Image And Focus With Focus Assistant - Axis P1311 Guia De Instalacion

AXIS P1311 Installation Guide

Adjust the image and focus with Focus Assistant

To focus the AXIS P1311 using the Focus Assistant
follow the instructions below.
1. Power-on the AXIS P1311 and wait about
1 minute.
2. Either mount or place the camera so that it
cannot be moved. See the notes below.
3. Set the camera to its extreme distant-focus
position by loosening the focus puller and
turning the lens fully clockwise.
4. Press and quickly release the Control button.
When the Status LED flashes green, the Focus
Assistant is enabled.
If the Status LED flashes either red or yellow
before you are able to adjust the lens, skip to
step 7 to exit the Focus Assistant and repeat
steps 3 -7. See the notes below.
5. Gently turn the lens anti-clockwise until it
stops. Do not force the lens too far or it will
separate from the camera.
6. Finally, turn the lens slowly clockwise until
the status indictor flashes green (not red or
yellow).
7. To exit the Focus Assistant, press the control
button again.
8. Retighten the focus puller.
9. Open the Live View page in your web browser
and check the quality of the image.
Notes:
• If the view in front of the camera changes during adjustment (e.g., a finger or other object is placed in front
of the lens, or if the camera is moved), steps 3 -7 will have to be repeated.
• If the control button is not released within two seconds, AXIS Dynamic DNS Service is enabled instead of
the Focus Assistant.
Control button
Status indicator
Page 11
Focus puller