Clean The Machine - Vollrath VCBA118 Manual Para Operadores

OPERATION (CONTINUED)
Adjustments
Granita consistency adjustment
To change the consistency, use a standard screwdriver to turn the
adjustment screw located on the each bowl as follows:
• Thicker product: Turn screw clockwise; the indicator moves toward
Max.
• Thinner product: Turn screw counter-clockwise; the indicator moves
toward Min.
Cold Drink temperature adjustment
Note: Beverage temperature control is only available when the Cold
Drink/Granita switch is set to the I (Cold Drink) position.
To adjust, turn the temperature control knob for each bowl as follows:
• Decrease temperature: turn clockwise
• Increase temperature: turn counter-clockwise
4

CLEAN THE MACHINE

NOTICE: Local and state health codes dictate the procedure
required. Some health codes require a four-sink process
(pre-wash, wash, rinse, sanitize, and air-dry), while other
codes require a three-sink process (without the pre-wash
step). The following procedure is a general guideline only.
Consult your local and state health codes for procedures
required in your location.
NOTICE: Hand wash only. Do not wash any components in the
dishwasher.
NOTICE: Do not use excessive amounts of water around the
electrical components. This could cause electric shocks or
damage to the machine.
NOTICE: Do not use abrasive materials, scratching cleansers or
scouring pads. Use only products designed for use with
plastic.
Empty and Clean the Bowl
1. Set the Main Power switch to the I position.
2. Set the Cold Drink/Granita switch(es) to the I position (Cold Drink).
3. Remove the condensation ring, located under the spigot.
4. Wait a few minutes for the product to thaw slightly.
5. Place a bucket under the spigot and open the spigot to drain the
product from the bowl.
6. Set the Main Power switch to the 0 (OFF) position.
7. Fill the bowl with cool tap water.
Tip: Use a Stera-Sheen® Green Label Sanitizer solution, prepared
according to the manufactures' instructions, to improve ease of
cleaning the parts.
8. Place the cover on the machine.
9. Set the Main Power switch to the I position.
10.Set the Cold Drink/Granita switch(es) to the I position (Cold Drink).
Allow the auger to turn for 30 seconds.
11.Drain the bowl.
12.Set the Main Power switch to the 0 (OFF) position.
13.Remove the components. See "Disassemble the Machine" on
page 5.
14.Wash the evaporator cylinder using a soft brush.
Clean and Sanitize the Components
1. Disassemble the machine. See "Disassemble the Machine" on
page 5.
2. Wash the parts shown below in warm, 90° to 110°F (32°C to 43°C)
mild detergent water.
3. Rinse the parts with clean 90° to 110°F (32°C to 43°C) water.
4. Place the parts shown below in a sanitizing solution for at least one
minute.
5. Remove the parts from the solution and let them air dry completely.
Do not remove the sanitizer from the parts.
Frozen Beverage Granita Machines Operator's Manual