Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Operating Instructions
Operation (Continued)
luBRIcatIon
Air tools require lubrication throughout
the life of the tool and is the owner's
responsibility. Failure to lubricate the air
tool properly will dramatically shorten the
life of the tool and will void the warranty.
BEFORE the initial use and BEFORE and
AFTER each additional use.
AutomAtic lubricAtion
The recommended method for
lubrication is with an air line lubricator
installed as part of the air piping system.
See Figure 1. Use Campbell Hausfeld air
tool oil ST127000AV or equivalent ISO
grade 32 oil.
mAnuAl lubricAtion
If an air line lubricator is not used, the
tool must be lubricated daily.
supply before lubricating.
1. Disconnect the air tool from the air
supply.
2. Turn the air tool upside down.
3. while pulling the trigger, squeeze
approximately a 1/4 oz. of Campbell
Hausfeld airtool oil in the air inlet. If
applicable, switch the forward and
reverse valve in both directions.
lubricated, oil will discharge through
the exhaust port during the first few
seconds of operation. The exhaust port
must be directed away from your body
before applying air pressure.
4
This air tool
requires lubrication
Disconnect the
air tool from the air
After an air tool
has been
www.campbellhausfeld.com
4. Connect the air tool to the air supply
and cover the exhaust port with a
towel (refer to replacement parts
manual for tool features). Run the
tool in both the forward and reverse
directions, if applicable, for 20 to 30
seconds. Oil will discharge from the
exhaust port when air pressure is
applied.
attachments
before changing attachments or serious
injury could occur.
1. Insert the 7/16 inch hex adapter into
quick change chuck. Push the sleeve
of the quick change chuck forward to
allow the adapter to lock in place.
Hex Adapter
Figure 2
stem is fully inserted into the chuck.
Loose attachments could fly off during
operation and cause serious injury. Only
use attachments rated for a minimum of
3,000 RpM.
2. Different attachments can be
threaded onto the adapter. 3/8 inch x
24 threaded drill chucks will fit on the
adapter.
Disconnect air
tool from air supply
Quick Change Chuck
Make sure
attachment
Tabla de contenido
