Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. For buffing wheel attachements, use
a 3/8 inch x 24 threaded nut to hold
the attachment onto the 7/16 inch
hex adapter.
Maintenance
Release all pressure before
attempting to install, service,
relocate or perform any maintenance on
the air system. personal injury and/or
property damage could occur.
stoRaGe
The air tool must be lubricated before
storing. An air motor cannot be oiled too
often.
before lubricating.
1. Turn tool upside down.
2. while pulling the trigger, squeeze
approximately a 1/4 oz. of Campbell
Hausfeld airtool oil in the air inlet. If
applicable, switch the forward and
reverse valve in both directions.
lubricated, oil will discharge through
the exhaust port during the first few
seconds of operation. The exhaust port
must be directed away from your body
before applying air pressure.
3. Connect tool to air supply and cover
exhaust port with a towel. Run the
tool for only 2 to 3 seconds because
more oil needs to remain in the air
tool when storing.
Disconnect air tool
from air supply
After an air tool
has been
www.campbellhausfeld.com
technIcal seRvIce
For information regarding the operation
or repair of this product, please call
1-855-504-5678.
Replacement paRts
InFoRmatIon
For information regarding where to order
replacement parts, call toll free 1-855-
504-5678.
Please provide the following information:
• Model number
• Stamped code
• Part number and description
Address parts correspondence to:
Campbell Hausfeld
100 Production Drive
Harrison, Ohio 45030 U.S.A.
CL252200AV
5
Tabla de contenido
