Pulsar TRAIL LRF XQ28 Instrucciones De Operación página 8

ZEROING
The sight features two zeroing methods - "one shot" zeroing and using
FREEZE function.
Zeroing should be done at operating temperatures, by following the order
of these steps:
Mount the rifle with the sight installed on a bench rest.
Set a target at a certain distance.
Adjust the sight according to the instructions of section "Powering on
and image setup".
Select the zeroing profile (see main menu option «Zeroing
Profile» )
Aim the firearm at the target and take a shot.
If the point of impact does not match the aiming point (centre of the
sight's reticle), hold down the M (4) button to enter the main menu.
Enter the submenu "Zeroing"
Set the zeroing distance value (see main menu option "Zeroing" =>
submenu "Add new distance"
Enter the submenu with a short press of the M button
Select icon with UP(3)/DOWN (5) buttons. Press briefly the M
button.
Additional menu for zeroing parameters setup appears on
the display
An auxiliary cross appears in the centre of display,
and coordinates of the auxiliary cross X and Y appear in
the top right corner (see Pic. 5).
Select icon with UP/DOWN buttons. Press briefly the M button.
Holding the reticle in the aiming point, move the auxiliary cross
horizontally or vertically with UP/DOWN buttons relative to the reticle
until the auxiliary cross matches the point of impact.
9
with a short press of the M button.
).
0
A100m
windage
x=31.00
y=26.00
Save the new position of the reticle with a long press of the М button.
Message "zeroing coordinates saved" confirms successful operation.
Menu exit takes place. The reticle will now move to the point of impact.
Exit the submenu,take another shot - the point of impact should now
match the aiming point.
The sight allows you to quickly increase the basic magnification (please
refer to the "Digital zoom" line in the specifications table) by two times
or four times (8 times in XP models), as well as to return to the basic
magnification. To operate the incremental digital zoom, press
successively the DOWN (5) button.
IMAGE DETAIL BOOST*
The "Image Detail boost" function increases the sharpness of the
contours of heated objects, which increases their detail. The result of the
function depends on the selected mode and observation conditions: the
higher the contrast of objects, the more noticeable the effect. This option
is enabled by default, but can be disabled in the main menu.
*XP models only
10