Pulsar TRAIL LRF XQ28 Instrucciones De Operación página 7

INSTALLATION:
Remove the protective cover from the
Battery Pack.
Lift the lever (13).
Install the battery into the dedicated slot
on the sight housing so that element F
(Pic.5) appears from below.
Fix the battery by clicking the lever.
The sight can be powered with an external power supply such as Power
Bank (5V).
Connect the external power supply to the USB port (10) of the sight
(Pic. 1).
The sight switches to operation from external power supply, and the
6 7 IPS7 Battery Pack will begin slowly charging.
Pic. 5
The display will show the battery icon
percentage.
If the sight operates on external power supply but the IPS7 battery is
not connected, the icon
When the external power supply is disconnected, the sight switches
to the internal battery pack without powering off.
INSTALLATION OF MOUNT
Before using the sight you need to install a mount (may not be
included).
The mounting holes (14)(pic.4 on the front flyleaf) in the base of the
sight enable the mount to be installed in one of the multiple positions.
The choice of the mounting position helps the user to ensure the
correct eye relief depending on the rifle type.
Attach the mount to the base of the sight using a hex-nut wrench and
screws.
Install the sight on the rifle and check if the position is suitable for you.
If you are happy with its position, remove the sight, unscrew the
screws halfway, apply some thread sealant onto the thread of the
screws and tighten them fully (do not overtighten). Let the sealant dry
for a while.
The sight is ready to be installed on a rifle and to be zeroed.
After first installation of your sight on a rifle, please follow instructions
in the section "Zeroing".
WARNING! Do not point the objective lens of the unit at intensive
sources of light such sight emitting laser radiation or the sun. This
may render the electronic components inoperative. The warranty
does not cover damage caused by improper operation.
Powering on and image setup
Open the lens cover (1).
Turn the unit on with a short press of the ON (11) button.
To obtain a crisp image of the icons on the display, rotate the dioptre
adjustment ring (7). After this there is no need to rotate the dioptre
adjustment ring for distance or any other conditions.
To focus on the object being observed rotate the lens focusing ring (2).
To set up display brightness and contrast and continuous zoom,
please refer to the QUICK MENU FUNCTIONS section.
After use, hold down the ON button to turn the sight off.
with charge level as a
is shown.
8