Spring Bar/Final Installation - Reese STEADI-FLEX Manual Del Propietário

BEFORE HITCHING: Measure the front wheel well height
of the tow vehicle before hitching or installing this weight
distributing system. Record this measurement.
FRONT WHEEL WELL HEIGHT BEFORE
INSTALLATION

SPRING BAR/FINAL INSTALLATION:

20. Use the trailer jack to lift the trailer coupler
above the hitch ball.
21. Back the tow vehicle so that the hitch ball is
directly under the trailer coupler.
22. Lower the trailer and attach the trailer to the
hitch ball. Lock the coupler before proceeding.
23. Insert spring bars (label up) into ball mount and
secure with clevis pin and spring clip (see Fig.
11).
24. Swing the spring bars so that they are
positioned slightly outboard of the adjustable
brackets.
25. Extend the trailer jack and raise the front of the
trailer and the back of the tow vehicle approx.
4" above level.
26. Use the lift handle to place the spring bar onto
the friction pads (See Fig. 12).
27. Remove the lift handle and swing the spring bar
cover down over the spring bar. Secure by
inserting the spring clip into the hole in spring
bar cover.
28. Repeat steps 23 & 24 for the other side.
AFTER HITCHING: Retract the trailer jack and measure
the front wheel well height with the weight distributing
system installed. Record this measurement
FRONT WHEEL WELL HEIGHT AFTER
INSTALLATION
Note: If H2 is less than H1, see pg. 9 for system adjustment.
66559N REV D
: H1=
: H2=
PCN18577 ©2014 CEQUENT
™
PERFORMANCE PRODUCTS, INC
Fig. 11
Fig. 12
8