Frame Bracket Installation - Reese STEADI-FLEX Manual Del Propietário

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

FRAME BRACKET INSTALLATION:

Item No.
Qty.
1
4
2
2
4
3
2
4
5
2
1. Use the measuring tape to locate a point 27-32" along the
A-Frame from the center of the coupler. Mark this
location with a pencil on both sides of the A-Frame (See
Fig. 3)
2. Insert a 3-1/2" long 5/8" bolt (1) through the large hole in
the T-Bar and single hole in the Clamping Bar.
3. Secure with a 5/8" lock nut (2) and hand tighten.
4. Slide the T-Bar and Clamping Bar over the frame where
the mark is located from step 1. The T-Bar must be
located on the outside of the A-Frame with the large hole
facing outward (See Fig. 4). Allow 1" of clearance on
either side of the T-Bar.
5. Insert a second 5/8" bolt from the inside through a conical
washer and the Clamping Bar and thread into the T-Bar.
Use the highest holes not obstructed by the bottom of the
frame (See Fig. 4).
Note: 1-1/2" wide frames require the 2-3/4" long
5/8" bolts (5) to fasten the bottom of the T-Bar and
Clamping Bar.
6. Snug the 5/8" nuts and confirm that the brackets are
installed correctly (See Fig. 5).
7. Repeat steps 1-6 for the other side of the A-Frame.
8. Torque all 5/8" hardware to 130 ft.-lbs.
66559N
REV D
Description
Hex Bolt 5/8"-11 x 3-1/2" GR5
5/8"-11 Lock Nut
5/8" Conical Washer
Hex Bolt 5/8"-11 x 1-1/4" GR5
Hex Bolt (For 1.5" Wide Frames)
5/8"-11 x 2-3/4" GR5
PCN18577
©2014 CEQUENT
Space
Correct
PERFORMANCE PRODUCTS, INC
Fig. 3
Fig. 4
Space
Incorrect
Incorrect
Fig. 5
Space
Incorrect
5
Tabla de contenido
loading

Este manual también es adecuado para:

665596656066561:

Tabla de contenido