Reese STEADI-FLEX Manual Del Propietário página 6

9. Slide the Adjustable Frame Bracket onto the T-Bar to the corresponding height for top/bottom
mounted coupler. For top mounted couplers, one threaded hole should be visible above the Adjustable
Frame Bracket. For bottom mounted couplers, the Adjustable Frame Bracket mounting bolt should
be fastened one bolt hole below the bottom frame bolt (See Fig. 6).
TOP MOUNTED COUPLER
10. Insert the short 5/8" bolt through a conical washer, Adjustable
Frame Bracket mounting hole and into the T-Bar. Hand
tighten the bolt. (See Fig. 7)
11. Repeat steps 9 and 10 for the other side of the A-Frame.
12. Torque all 5/8" hardware to 130 ft.-lbs.
Note: Use this vertical mounting location as a starting
point. For system adjustment, see pg. 9
66559N REV D
(6" Tall Frame Shown)
PCN18577 ©2014 CEQUENT
BOTTOM MOUNTED COUPLER
(6" Tall Frame Shown)
Fig. 6
SHORT 5/8" BOLT
5/8" CONICAL
WASHER
™
PERFORMANCE PRODUCTS, INC
Fig. 7
6