Sammic X-60/B Instrucciones página 9

level.
·'LOW FLOAT' LED: Break Tank Low Float
LED. ON; when the low float has been
actuated, meaning the water level has reached
this point.
Output LEDs: They identify the item that has
been activated by the microprocessor. Their
location and description are indicated on the
silk-screened board and on Figure B. The
following are red LEDs:
·'PRES. PUMP' LED: ON, when the pressure
pump is working.
·'DRAIN PUMP' LED: ON, when the drain
pump is active.
·'S.V.' LED: ON, when water is allowed to flow
through the solenoid valve.
·'WASH. PUMP' LED: ON, when the washing
water pump is operating.
·Reserve LED: associated with a spare output.
·'BOILER RESISTOR CONTACTOR' LED:
ON, when the boiler resistor is heating water.
·TUB RESISTOR CONTACTOR LED: ON,
when the tub resistor is heating water.
Those LEDS show the status of the outputs
activated by the microprocessor. Accordingly,
when one LED is on, the associated component
must also be active.
Example: If the Washing Water Pump LED is
on and the pump does not work, this means that
the microprocessor gives the order correctly
and the fault lies in an external item such as the
contactor or the pump.
The status of the inputs can be determined
according as the respective LEDs are on or off.
OTHER IMPORTANT REMARKS
· This machine is not designed to be used by
individuals (including children) with reduced
physical, sensorial or mental facilities, or who
lack the relevant experience or knowledge,
unless they are supervised by or have
received instruction on how to use the
apparatus from a person responsible for their
safety.
· Before cleaning, servicing or repairing the
machine, it is necessary to unplug it from the
mains.
· When the appliance is going to be inactive for
a long period of time or at night, the door
should be kept open for aeration and avoiding
nasty smell.
· In case of a drain pump failure:
1.Drain the wash tank into a container until
the water level drops below the drain plug.
2.With the drain plug in place, remove the
front bottom panel and change the pump
(this can be done without moving the
machine). In order to drain the dishwasher
manually, connect a drain hose to the
collector. On pulling out the drain plug,
water flows out of the tank by gravity.
· In the event the power supply cable should get
damaged and have to be replaced, the repair
may only be done by a SAMMIC approved
assistance service.
· Airborne noise: the emission noise level
measured on a typical machine is lower than
70 dB(A) at a distance of 1m.
ENGLISH 9