Tabla de contenido
Idiomas disponibles
Idiomas disponibles
GB
FR
DE
ES
MAINTENANCE
GENERAL
All other parts represent an important part of the class
II insulation system and should be serviced only by a
quali¿ ed service technician.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents. Use clean cloths to remove
dirt, dust, oil, grease, etc.
Do not at any time let brake À uids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
It has been found that electric tools are subject to
accelerated wear and possible premature failure when
they are used on ¿ berglass boats, sports cars, wallboard
or plaster.
The chips and grindings from these materials are highly
abrasive to electric tool parts such as bearings, brushes,
commutators, etc.. Consequently, it is not recommended
that this tool be used for extended work on any ¿ berglass
material, wallboard or plaster. During any use on these
materials it is extremely important that the tool is cleaned
frequently by blowing with an air jet.
LUBRICATION
All of the bearings in this tool are lubricated with a
suf¿ cient amount of high grade lubricant for the life of
the unit under normal operating conditions. Therefore, no
further lubrication is required.
Keep extension cords away from the cutting area and
position the cord so that it will not get caught on lumber,
tools, etc., during cutting operation.
Check extension cords before each use, if damaged
replace immediately. Never use tool with a damaged
cord as touching the damaged area could cause
electrical shock resulting in serious injury.
Extension cords suitable for use with your saw are
available at your nearest service center.
IT
NL
PT
DK
SE
WARNING
CAUTION
WARNING
FI
NO
RU
PL
CZ
English
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
ENVIRONMENTAL PROTECTION
SYMBOL
V
Hz
W
n
o
min -
1
5
HU
RO
LV
LT
EE
WARNING
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
Safety Alert
Volts
Hertz
Alternating Current
Watts
No-load speed
Revolutions or reciprocations per minute
Maximum cutting capacity in wood
CE Conformity
Double insulation
Wear ear protection
Wear eye protection
Please read the instructions carefully before
starting the machine.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
HR
SI
SK
GR
TR
Tabla de contenido
