Special Safety Rules - Ryobi EJ700L Manual De Utilización

GB
FR DE ES

SPECIAL SAFETY RULES

„ If operation is dusty, also wear a dust mask.
„ Wait for the cutter to stop before setting the tool
down. An exposed cutter may engage the surface
leading to possible loss of control and serious injury.
„ Hold power tool by insulated gripping surfaces
only, when performing an operation where the
cutting accessory may contact hidden wiring or its
own cord. Cutting accessory contacting a "live" wire
may make exposed metal parts of the power tool "live"
and shock the operator.
„ If the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his
agent in order to avoid a safety hazard.
LASER GUIDE
The laser guide radiation used in saw is Class 2M with
maximum <5mW and 650nm wavelengths. These lasers
do not normally present an optical hazard, although
staring at the beam may cause À ash blindness.
DO NOT stare directly at the laser beam. A hazard may
exist if you deliberately stare into the beam, please
observe all safety rules as follows:
„ The laser shall be used and maintained in accordance
with the manufacturer's instructions.
„ Never aim the beam at any person or an object other
than the work piece.
„ The laser beam shall not be deliberately aimed at
personnel and shall be prevented from being directed
towards the eye of a person for longer than 0.25s.
„ Always ensure the laser beam is aimed at a sturdy
work piece without reflective surfaces such as wood
or rough coated surfaces are acceptable. Bright shiny
reflective sheet steel or the like is not suitable for laser
use as the reflective surface could direct the beam
back at the operator.
„ Do not change the laser guide assembly with a
different type. Repair must only be carried out by the
laser manufacturer or an authorised agent.
„ Save these instructions. Refer to them frequently and
use to instruct other users. If you loan someone this
tool, loan them these instructions too.
SPECIFICATIONS
Voltage
Input power
IT NL PT DK SE
WARNING
230 V
680 W
FI NO RU PL CZ
English
Stroke per minute
Stroke length
Max cutting capacity
Wood
Steel
FEATURES
KNOW YOUR SAW
Before attempting to use your saw, familiarize yourself
with all operating features and safety requirements.
ELECTRICAL CONNECTION
Your saw has a precision built electric motor. It should be
connected only to a power supply of the type speci¿ ed by
its rating plate. Do not operate this tool on direct current
(DC). A substantial voltage drop will cause a loss of power
and overheating. If your tool does not operate when
plugged into an outlet, double-check the power supply.
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
suf¿ cient to inÀ ict serious injury.
OPERATION
SWITCH
See Figure 1.
„ To turn your saw on, depress the switch.
„ Release switch trigger to turn your saw OFF.
LOCK-ON BUTTON
See Figure 1.
Your saw is equipped with a lock-on feature, which is
convenient when continuous cutting for extended periods
of time is required. To lock-on, depress the switch trigger,
push in and hold the lock-on button located on the side of
the handle, then release switch trigger. Release lock-on
button and your saw will continue running.
To release the lock, depress the switch trigger and
release.
If you have the lock-on feature engaged during use and
your saw becomes disconnected from power supply,
disengage the lock-on feature immediately.
50 Hz
1
HU RO LV LT EE
WARNING
HR SI SK GR TR
-1
800 - 3000 min
21 mm
85 mm
8 mm