Canopy Assembly; Light Kit Assembly (Optional). Pgs; Important - Craftmade BW248AG6 Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that was
removed and then tighten both screws securely. Slide
canopy cover up to canopy, aligning rounded part of
slotted holes in canopy cover with screwheads in
bottom of canopy. Turn canopy cover to the right
(clockwise) until it stops.
*Remember that antenna for remote control receiver
must rest outside of hanging bracket.
8. Light Kit Assembly (Optional).
If you wish to USE the light kit, remove 1 screw from
motor plate on underside of motor assembly and
partially loosen the other 2 screws. Align slotted holes
in large fitter plate with loosened screws in motor
plate, allowing molex connections from motor
assembly to come through hole in middle of large fitter
plate. Twist large fitter plate to lock. Re-insert screw
that was previously removed and securely tighten all 3
screws with Phillips screwdriver.
Remove 1 screw from post on underside of large fitter
plate and partially loosen the other 2 screws.
Connect WHITE wire from motor assembly to WHITE
wire from light kit fitter. Connect BLACK (or BLUE) wire
from motor assembly to BLACK wire from light kit
fitter. Be sure molex connections snap together
securely.
Align slotted holes in light kit fitter with loosened
screws in large fitter plate. Twist light kit fitter to lock.
Re-insert screw that was previously removed. Tighten
all 3 screws securely.
Install two 13 watt compact fluorescent medium base
bulbs (included).
IMPORTANT: When you need to replace bulbs,
please allow bulbs and glass shade to cool down
before touching.
Hg
LAMP CONTAINS MERCURY
Manage in accordance with Spills, Disposal and Site Cleanup
Requirements. In case of breakage, follow clean-up
procedures provided by contacts below.
www.epa.gov/cflcleanup
1-866-284-4010
["Light Kit Assembly" continued on next page.]
screw
canopy
light kit fitter
page 7
antenna
hanging bracket
screw
canopy cover
motor
assembly
motor plate
large fitter plate
molex connections
motor
assembly
large
fitter plate
molex connections
bulb