Fan Assembly. Pgs - Craftmade BW248AG6 Guia De Instalacion

5. Fan Assembly.
If you wish to extend the hanging length of
your fan, you must remove the hanging ball
from the 4½in. downrod provided to use with
an extended downrod (sold separately). [If you
wish to use the 4½in. downrod, please proceed to
instructions following the dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove
stop pin. Slide hanging ball off the original
downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging
ball. Be sure stop pin aligns with slots on the
inside of the hanging ball. Tighten set screw
securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
Locate canopy cover in hardware pack. Loosen
yoke set screws and nuts in yoke at top of
motor assembly. Remove pin and clip from
motor assembly yoke. Slide downrod through
canopy, canopy cover* and yoke cover.
*NOTE: Canopy cover must be turned with
shiny side toward the motor assembly.
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the
upper end of the downrod.
Thread downrod into the motor assembly yoke
until holes for pin and clip in downrod align
with holes in yoke--make sure wires do not get
twisted. Re-insert pin and clip. Securely tighten
yoke set screws and nuts. Lower yoke cover to
motor assembly.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common
sense and caution are necessary factors in the
installation and operation of this fan.
set screw
A
electrical wiring
canopy
yoke cover
clip
page 4
set screw hole
stop pin
hanging ball
B
safety cable
downrod
canopy cover
yoke set screw
and nut
pin
motor
assembly