Magura HYMEC Manual Del Usuario página 28

28
HYMEC-Installation
Sportster
Tools required:
❚ 8 mm wrench
❚ 14 mm wrench
❚ Torx wrench set
❚ Medium-sized screwdriver
❚ Wire cutter or sharp knife
On delivery, the system is completely filled.
The system must be opened for installation.
No fluid may be allowed to escape as this
Instruction:
01. Remove the clutch cover on the left-hand side of the motor.
02. Remove the clutch cable by taking off the nut with spring and then backing off the adjusting
screw of the clutch with the screwdriver and so that the ramp assembly can be rotated.
Remove the cable coupling from the outer ramp. Then remove the clutch cable from the
primary cover. Remove the mechanical clutch lever from the handlebar.
03. Reinstall the cable coupling and the ramp assembly; set the clutch according to the
factory instructions (loosen the counter nut; screw it in as far as it will go and then 1/2 to
3/4 revolutions back; replace nut with spring).
04. Remove the hydraulic system from the packaging.
could subsequently impair the proper func-
tioning of the system. It is therefore essential
that the following installation instructions be
followed exactly. To ensure a precise fit, the
hydraulic system is locked with a spacer in
the slave cylinder during installation. Do not
actuate the master cylinder prematurely! Do
not remove the spacer prematurely; remove
it according to the instructions! If additio-
nal hydraulic fluid is required, use only
MAGURA mineral oil; available in either 2 or
10 ounce bottles.
fig. 1
ramp assembly
ball on
cable end
end cap
cable coupling