Proxxon FBS 240/E Manual Del Usuario página 10

Machine description
The PROXXON FBS 240/E precision bore grinder is desi-
gned for grinding and boring operations too precise and
detailed for standard drills. The precision bore grinder is
ideal for working on steel, non-ferrous metal, glass,
wood, ceramics and more. Its applications include preci-
sion boring, grinding, polishing, brushing, derusting,
engraving, enchasing, and disagreggating.
The quiet-running permanent-magnet motor provides
powerful torque over the entire speed range. The anti-
lash precision ball bearings of the drill spindle facilitate
optimal true-run turning. The spindle head is turned out
for easy mounting of PROXXON collet chucks (available
as accessory).
Technical data
Length:
Weight:
Chuck capacity:
Spindle collar:
Protection class II device
Use indoors only
Please do not dispose off the machine!
Motor:
Rotational speed
Voltage
Power consumption
Noise emission
Vibration
Accessories:
For more information regarding accessories, ask for our
equipment catalogue at the address provided on the last
page beneath the warranty information.
- 10 -
approx. 200 mm
approx. 400 g
0.5 to 3.2 mm
ø 20 mm
5,000-20,000/min
~230 V, 50/60 Hz
100 W
≤ 70dB (A)
≤ 2.5 m/s
2
Operating instructions
Clamping and changing the bit
Important!
Unplug machine before changing bit.
Never press lock button 1 (Fig. 2) with machine running.
1. Slightly turn drill chuck 2 (Fig. 2) and simultaneously
press lock button (1) until the latter engages.
2. Open chuck and change bit.
When clamping drill bits, insert to minimise projecting
length. Long shafts bend easily and degrade true run.
We recommend PROXXON collet chucks for optimal true
running.
Using the machine
Important!
Always wear protective goggles when using the
machine.
Never use damaged grinding wheels or bent shafts.
1. Switch on machine at switch 4 (Fig. 1) and set the
appropriate operating speed at button 1 (Fig. 1).
Optimum grinding results are achieved through uniform
speed and not by applying excessive pressure.
Small cutters/bits = high speed,
Large cutters/bits = low speed.
2. When cutting or engraving, hold the machine as if it
were a pen (Fig. 3), being careful not to occlude the
vent slits.
3. For roughing down, grip the machine as if it were a
hammer (Fig. 4).
Note: