Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Before You Begin
Tools and Parts Needed
▯
Phillips Head Screwdriver
▯
Pencil
▯
Drill with ¼" (6 mm) bit
▯
Jigsaw
▯
Tape Measure
Note: Additional materials may be necessary for
installation in solid surface countertops. Contact the
countertop manufacturer.
Parts Included
Cabinet Requirements
The distance from the top of the cooktop to the
bottom of cabinets above must be a minimum of A=30"
(762 mm). This distance can be reduced to A=24"
(610 mm) when the bottom of the wood or metal
cabinet is protected by not less than ¼" (6.35 mm)
flame-retardant millboard covered with not less than
no. 28 gauge sheet metal, 0.015" (0.4 mm) stainless
steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm)
copper.
Verify that the cabinets above the cooktop are a
maximum of B=13" (330 mm) deep.
Countertop Requirements
9
WARNING
To reduce the risk of ignition of surrounding
combustible materials, install at least
2" (51 mm) from both sidewalls and the rear
wall.
The countertop must be level and horizontal. The
stability of the countertop must be maintained after
the cut-out has been made.
Solid surface countertops often require special
installations. For example, heat-reflective tape and
rounded corners may be necessary. Contact the
countertop manufacturer for instructions specific to
your countertop.
5
Tabla de contenido
