In-Car Connection - Philips AZ7680 Manual De Usuario

IN-CAR CONNECTION

In-car use
(connections supplied or optionally available)
Only use the AY 3545 car
voltage converter (4.5 V, DC,
positive pole to the center pin)
and the AY 3501 car adapter
cassette. Any other product may
damage the set.
1 Put the CD player on a
horizontal, vibration-free and
stable surface. Make sure it
is a safe place, where the
player is no danger or
obstacle to the driver and passengers.
2 Connect the DC plug of the voltage converter to the 4.5V DC socket of the CD
player (only for a 12 V car battery, negative grounding) .
3 Insert the voltage converter into the cigarette lighter socket. If necessary, clean the
cigarette lighter socket to obtain a good electrical contact.
4 Turn down the volume and connect the adapter cassette plug to the p socket of the
CD player.
5 Carefully insert the adapter cassette into the car radio's cassette compartment.
6 Make sure the cord does not hinder your driving.
7 Start the CD player, set VOL E to position 8 and adjust the sound with the car
radio controls.
• Always remove the voltage converter from the cigarette lighter socket when the CD
player is not in use.
Notes: – Avoid excessive heat from the car heating or from direct sunlight (e.g. in a
parked car in the summer).
– If your car radio has a LINE IN jack, it is the best to use it for the car radio
connection instead of the adapter cassette. Connect the signal lead to this
LINE IN jack and the p jack of the CD player.
16
4,5 V DC
0