Tabla de contenido
1.1 UNPACKING
Remove all the protective packing
pieces.
Check
appliance's characteristics that appear
on the nameplate
Note
the
service
references shown on this plate in the
boxes below for future reference.
1. 2 INSTALLATION
Emplacement with cutlery drawer
If you wish to mount furniture or a drawer
under the hob, a separation board must
be fitted between the two. Accidental
contact with the hot surface of the
device's housing is thus prevented.
The board must be fitted 20 mm under
the bottom cover of the hob. (1.2.1)
Installation above an oven See the
minimum distances scheme (1.2.3)
Installation of the seal see scheme
(1.2.4)
and
respect
the
and
standard
1.3
ELECTRICAL
Before you connect the hob to the mains,
check if the voltage and frequency match
those specified on the hob label, which is
placed
under
Guarantee card, or if applicable on the
technical data sheet, which you must
keep
together
throughout the product's service life.
The electrical connection will be via an
all-pole circuit breaker or plug, whenever
accessible,
in
the current and with a minimum 3
mm distance between contacts. This
ensures disconnection in emergencies
and allows hob cleaning.
Only the official technical service can
handle
or
repair
including replacement of the power
cable.
Ensure that the inlet cable does not
come
into
contact
housing or the oven housing, if it is
installed in the same unit.
Warning:
The
electrical
properly grounded, following current
regulations, otherwise the hob may
malfunction.
Unusual high power surges
can damage the control system (like with
any electrical appliance).
Keep
the
Guarantee
the technical data sheet together with
the instructions
the product's
contain important technical information.
23
CONNECTION
the
hob
or
on
with
this
manual
accordance
the
appliance,
with
the
connection
must
Certificate
manual
throughout
service
life.
These
the
with
hob
be
or
Capítulos
Tabla de contenido
