Startup Procedure - Infrico EVV100 Manual De Instalación Y Funcionamiento

plate located on an inner wall of the unit. Verify that this information exactly matches the
electrical characteristics at the installation location.
NOTE: This sticker is placed on the power supply wire.
It prevents us from the electrical risk of the device.
NOTE: The device must be plugged in to an exclusive circuit for this purpose. The violation
of this requirement results in warranty cancellation
NOTE: The unit is designed to operate with a voltage fluctuation of 5% of the voltage
indicated on the cabinet serial data plate. Burnout of the compressor due to exceeding the high
or low voltage limits will automatically void the factory warranty.
Devices are provided from factory with cord and plug as shown in the figure.
If the correct electrical outlet is not provided, you should previously install it.
WARNING: Any alterations to this cord and plug could cause an electrical hazard and will
void the factory warranty. Furthermore, never use an adapter plug.
WARNING: The manufacturer will not warranty any units that are connected to an
extension cord.

8 STARTUP PROCEDURE

After the cabinet has been installed, levelled, cleaned and electrically connected in
accordance with this manual, it is ready to operate. Simply plug the unit in to begin operation.
The system should run smoothly and quietly in accordance with generally accepted
commercial standards. If any unusual noises are heard, turn the unit off immediately and check for
any obstructions of the fans.
.
28