Uncrating; Ventilation - Infrico EVV100 Manual De Instalación Y Funcionamiento

NOTE: Is very important, avoid direct contact of the air conditioning apparatus.

6.2 Uncrating

These units are shipped from the factory on a wooden pallet and packaged in a wooden
container. The wooden is attached to the wooden base with the use of large staples. These should
be first removed to avoid scratching the unit when lifting off the crate.
All packaging materials used are environmentally friendly and may be recycled or reused.
Actively contribute to the protection of the environment by insisting on packaging recovery and
removal methods that are environmentally friendly.
NOTE: The manufacturer does not recommend laying the unit down on its front, side or
back. However, you must be certain to allow the unit to remain in an upright position
afterwards for at least 24 hours before plugging it in so that the compressor oil and refrigerant
may settle.

6.3 Ventilation

To assure maximum operating efficiency, the equipment should be located where a
continuous air supply can circulate underneath and behind the cabinet. To facilitate an adequate
flow of air, the device has spacers located at the rear.
Restricting the air supply will generate an excessive heat load on the condensing unit and
adversely affect its operating efficiency. Do not at any time obstruct the grill area in the front of
the cabinet in any way.
300 mm minimum space on the front
26
of the unit.