Leveling; Initial Cleaning Procedure; Electrical Instructions - Infrico EVV100 Manual De Instalación Y Funcionamiento

NOTE: Any restriction of the proper air flow, total or partial, will avoid the warranty on the
unit.

6.4 Leveling

Its extremely important that the cabinet is perfectly level for proper operation so that the
drain pan will drain properly, the doors will line up with the frames and the unit will not be subject
to undue strain.
These models are supplied with non-adjustable casters allowing easy cleaning of the floor
under the unit. In this case, just ensure the floor where the unit is located is level. To operate in a
stable condition, the front casters must be locked.

6.5 Initial cleaning procedure

It is recommended to clean all exterior surfaces of the furniture with a clean cloth
(preferably cotton or microfiber to avoid scratching the surface of the furniture) that is slightly
moistened only with water. For a deeper cleaning, you can moisten the cloth with warm water and
a little neutral soap. And do not forget to rinse it well. Next, dry the furniture very well with a soft
and dry cloth so that the wood does not get wet.
To clean the inside of the furniture, use mild soap and warm water. After cleaning, rinse
thoroughly with water and dry with a soft cloth.
NOTE: Never use harsh or abrasive cleaners, concentrated detergents, solvents or
chemicals to clean the equipment. Remember that products that contain bleach or ammonia are
very damaging to the surface of the steel.

7 ELECTRICAL INSTRUCTIONS

The supply voltage should be checked before connection to assure that proper voltage for
the cabinet wiring is available. To determine correct unit voltage, please refer to the serial data
27