Precommissioning - Kärcher KM 85/50 R Bp Manual Del Usuario

– Operating hours
– Battery charge
– Next service
– Software version
Ignition key
3
– Remove the ignition key: Every time you leave the device
– Position 0: Device is off
– Position 1: Device is ready for operation
Wet sweeping flap
4
– Open for sweeping wet or damp surfaces
Selector switch for direction of travel
5
– Push switch back: reverse
– Push switch forward: forwards
Horn
6
– Press switch to warn of danger
Seat adjuster
7
– Pull lever to adjust seat horizontally
Steering wheel height adjustment
8
– Open the nut to adjust the height
Waste container
Transport rolls
1
Waste container
2
Waste container lock
3
Storage area
4
– Max. load 20 kg
Fastening lugs
5
Safety devices
The device has a seat contact switch as a safety device.
It brings the device to an abrupt halt if the driver gets up out of the
driver's seat whilst the vehicle is in motion.
The safety devices must not be removed or modified.

Precommissioning

Opening / closing the cover
CAUTION
Risk of crushing fingers
Only use the recessed grip provided to open and close the cover.
Note
It is necessary to open the cover:
1 to connect / install the batteries.
2 to charge the batteries.
3 to clean / replace the dust filter.
4 to replace the roller brush.
Recessed grip
1
Cover
2
Cover in rest position
3
Closing the cover
4
1. To open the cover, take hold of the recessed grip at the front
and pivot it backwards.
2. The cover is held at the end of the elongated hole in the rest
position by the locking rod.
3. To close the cover, push the locking rod upwards so that it
does not engage in place, then slowly pivot the cover down.
Unloading instructions
DANGER
Risk of accidents when unloading the device
Use a suitable ramp when unloading the device.
Do not use a forklift to unload / load the device.
Be aware of the weight of the device when unloading / loading.
DANGER
Risk of overturning in case of improper handling
Do not drive onto or from the ramp at an angle.
Do not turn on the ramp.
Drive at an adapted speed.
1. Connect the battery and charge it as necessary (see chapter
"Battery").
2. When delivered on a pallet: drive or push the device off the
pallet using a suitable ramp (see chapter "Pushing / driving the
device").
If the device is delivered on a pallet, build a ramp to drive the de-
vice down using the boards included.
1 Cut the plastic packing strips and remove the film.
2 Connect the battery (see chapter "Batteries / chargers").
3 Remove the tightening strap fasteners.
English 17