GYS NOMAD POWER 30 COMPRESSOR Manual Del Usuario página 10

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
Translation of the original instructions
CHARGING INSTRUCTION
1. Plug the home adaptor into the universal socket.
2. Connect 15V 1A input port
Or
1. Plug the car adaptor into the socket of cigarette lighter.
2. Connect 15 V 1 A input port
USING AS JUMP START
!
RECHARGE THE NOMAD POWER before first use and after each use.
1. Connect the Jumper cable with clamps into the host
is off.
2. Connect red clamp to the positive (+) battery terminal, black clamp to the negative (-)
battery terminal.
3. Operate following the instruction of the cable indicator :
4.Start the vehicle.
Only start when the NOMAD POWER's charging percentage is higher than 70%.
The ideal is 100% for maximum capacity.
Do NOT Jump Start more than 3 times in a row. It could damage the unit by overheating.
Give two minutes between attempts.
The jumping cable may overheat. In this case a protection system cuts the tension at the
clamps.
5.When the vehicle is started, remove the jumper cable from the vehicle battery. Leave the vehicle's engine running.
Remove the product from the vehicle battery within 30 seconds of Jump Starting. If not, it
could lead to damage.
10
NOMAD POWER 30 COMPRESSOR
Fig.1
of NOMAD POWER to the other end of home adaptor
6
of NOMAD POWER to the other and of car adpatator.
6
GREEN LIGHT On :
Telling the connection is correct and
the circuit is working, you can turn
on the engine to jump-start directly.
GREEN LIGHT blinking with buz-
zing :
Saying the vehicle battery is low,
press the «BOOST» button, wait
GREEN LIGHT becomes solid, then
turn on the engine within 30s.
Fig.2
, and make sure the Cable Indicator
2
RED LIGHT On with buzzing :
Telling the connection is wrong,
and buzzing to alarm to correct the
clamps as step 2 mentioned above,
wait until the GREEN LIGHT is on to
turn on the engine.
No lights on, no buzzing :
Saying the vehicle's battery may-
be damaged, after confirmed the
clamps connection is correct, press
the «BOOST» button, wait GREEN
LIGHT is on, and then turn the en-
gine within 30s.
EN
Tabla de contenido

Solución de problemas

loading

Tabla de contenido