MTD 19A30003OEM Manual Del Operador página 9

Note: This universal mounting bracket assembly is
designed to work with other available attachments, such
as a weight kit used in conjunction with the snow blade or
snow thrower attachment. Utilize the contact information
on page 2, or contact the retailer in which you purchased
this equipment, to find out more about available
attachments for your specific tractor.
2. Flip over assembly and mount the hitch support bracket to
the mounting assembly using four 710-3008 hex bolts and
712-04063 flange lock nuts from hardware pack 689-00319.
See Figure 4-4 for proper orientation.
For 700 models
Figure 4-4
Note: When attaching the hitch support, it is best to not
fully tighten the bracket at this time. This will facilitate the
mounting process in later steps, which will then require
fully tightening of this hitch support bracket.
Mount Assembly on Tractor
Install mounting assembly onto 900 Series tractors as follows:
1. Place the hooked ends of the mounting assembly over the
shoulder bolts, as in Figure 4-5, on the tractor and line up
the hitch support bracket center hole with the hole on the
tractor's hitch.
Figure 4-5
For all other models.
(900 Series Tractors)
2. Install the clevis pin (711-309A) from hardware pack 689-
00319 into the tractor's hitch and secure with a hairpin clip
(714-0117). See Figure 4-6.
Note: The clevis pin can be fed down through the hitch
plate and secured underneath with the hairpin clip, or it
may be easier to feed the clevis pin up through the hitch
plate hole and secure with the hairpin clip on the topside.
The latter method may be preferred since it can be easier
to insert the hairpin clip. Either way will work, the decision
should be based on operator preference.
Note: If you decided to leave the hitch support only
finger tight during the assembly process, tighten all of the
hardware securely at this time.
Figure 4-6
Installing the Mounting Assembly onto a 700 Series Tractors
Install the mounting assembly on the tractor as follows:
1. Place the hooked ends of the bagger mounting assembly
over the shoulder bolts, as in Figure 4-7, on the tractor and
line up the hitch support hole on the mounting assembly
with the hole on the tractor's hitch.
Figure 4-7
S
ection
Align hole on bracket
with hole on tractor
4 — A & i
SSembly nStAllAtion
9