Master Forge CBC835L Manual Del Usario página 6

aSSeMBlY iNStrUCtioNS
1. Attach air vent (C) to lid (B) using one small screw (AA) and one
wing nut (EE).
Attach handle (A) to lid (B) using two washers (HH), two washers
(GG) and two wing nuts (FF).
hardware Used
M5 x 12 mm
aa
Small Screw
ee
M5 Wing Nut
FF
M6 Wing Nut
GG
6.4 mm Washer
6.4 mm Heat Resistant
hh
Washer
2. Attach ash receiver support (K) to bottom bowl (I) using one
medium screw (BB) and one wing nut (FF).
hardware Used
M6 x 12 mm
BB
Medium Screw
FF
M6 Wing Nut
3. Attach front legs (M), rear legs (N) and leg support cups (J) to
bottom bowl (I) using four large screws (CC) and four
washers (GG).
Note: Do not fully tighten the large screws (CC) till end of step 4.
hardware Used
M6 x 30 mm
CC
Large Screw
GG
6.4 mm Washer
1
x 1
x 1
x 2
x 2
x 2
2
x 1
x 1
3
x 4
x 4
6