Install The Hardware; Replace The Dome Cover - Axis Q60 Serie Manual Del Usuario

Install the Hardware

NOTICE NOTICE NOTICE
• The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the switch shall be shielded (STP) and intended for their specific use. Make
sure that the switch is properly grounded. For information about regulatory requirements,
see Regulatory Information, on page 2.
• The product has a dehumidifying membrane for maintaining low humidity levels inside the
dome. To avoid condensation, do not disassemble the product in rain or damp conditions.
• Be careful not to scratch, damage or leave fingerprints on the dome cover because this
could decrease image quality. If possible, keep the protective plastic on the dome cover
until the installation is complete.
The Axis product can be installed with the cables routed through or along the wall or roof.
In areas where the temperature is above 60 °C (140 °F), the product shall be placed in a restricted
access location.
Read all the instructions before installing the product. Some installation steps would benefit from
being completed together because they require removal of the dome cover.
• Remove the protective packaging between the camera and the sunshield before installing
the camera.
• A smoked dome cover can be purchased from your Axis reseller. To replace the dome
cover, see page 22.
• A standard or high capacity SD card (not included) can be used to store recordings locally
in the product. To install an SD card, see page 23.
• To install the power supply (sold separately) and the supplied media converter switch,
see page 24.
• To install the network camera using a compatible bracket from AXIS T91A Mounting
Accessories (sold separately), see Install the Network Camera.

Replace the Dome Cover

Replacing the dome cover is only necessary if you want to use a smoked dome cover or if the
dome cover is scratched or damaged. Smoked dome covers and spare clear dome covers can be
purchased from your Axis reseller.
1. Loosen the dome ring screws and remove the dome cover.
2. Remove the dome bracket screws and remove the dome bracket and the dome cover
from the dome ring.
3. Make sure the rubber gasket is fitted correctly on the dome cover.
4. Align the bulge on the dome cover with one of the logotypes on the dome ring.
22
AXIS Q60 Series