Bushnell stableview 18-1035 Manual De Referencia Rápida página 5

1) Load two AA alkaline batteries into the compartment on the handstrap.
2) Press the Power button (a) to turn on. The electronic system will start up, and the binoculars will go
to Standby mode after about five seconds. (LED indicator stops blinking
3) Adjust the eyepiece spacing (b) to match the distance between your two eyes.
4) Use your left eye as you adjust the focus control knob (c). When the image becomes sharp, use your
right eye and turn the diopter adjustment ring (d) to focus for the right eye. Once you have performed
the diopter correction, use only the control knob (c) to check focus again.
5) Turn the stabilization lever (e) to the ACTIVE position to activate the stabilization feature.
6) Press the power button briefly to change to fine mode, which is more effective at countering hand
shake. Tap the power button again to return to normal mode.
7) When finished, turn the stabilization lever (e) to the HOLD position and press the Power button (a)
to turn off.
LED
Lit in orange
Lit in green
Flashing in orange/green Fine mode
Lit in red
Flashing in red
Off
Q U I CK REFERENCE GU ID E
Status
Standby (stabilization off)
Stabilization active (normal)
Batteries should be replaced
System problem
Power Off