Bushnell stableview 18-1035 Manual De Referencia Rápida página 11

STABILIZATION OPERATION
When you press the Power button the first time, the LED lights in
orange, and the binoculars go to Standby mode. Your Bushnell StableView
binoculars go through an internal system check and take about five
seconds to stabilize their performance.
Then, turn the stabilization lever to the ACTIVE position. The LED turns
green, indicating that the stabilization feature is active.
Stabilization Mode Switching
There are 2 stabilization modes: the regular stabilization
mode (normal mode), and enhanced stabilization mode (fine
mode).During use in normal mode, you can switch to fine
mode. In fine mode, cancellation of rapid vibration is
improved over normal mode, achieving sharp, hand held
images. However, as panning (tracking of the target) motion
is not counteracted in fine mode, it is recommended that you first locate the
target in normal mode, then switch to fine mode for observation.
Mode Operation
Use the power button to switch the stabilization modes.
During normal mode operation (Power ON; stabilization lever at
ACTIVE position), hold down the power button briefly then release to
operate in fine mode.
Stabilization Lever
LED
Lit in orange
Lit in green
Flashing in orange/green
Lit in red
Flashing in red
Off
Power Button
LED
Indicator
Status
Standby (stabilization off )
Stabilization active (normal)
Fine mode
Batteries should be replaced
System problem
Power Off
5