Alpine IVA-W200 Manual De Instrucciones página 71

5
Slide the IVA-W200 into the dashboard until it clicks.
This ensures that the unit is properly locked and will
not accidentally come out from the dashboard.
Removal
1. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
2. Pull the unit out, keeping it unlocked as you do so.
Foot Brake Lead / Parking Brake Lead Connection
FOOT BRAKE
(Yellow/Black)
IVA-W200
PARKING BRAKE
(Yellow/Blue)
Connection Diagram of SPST Switch (Sold Separately)
(If the ACC power supply is not available)
IVA-W200
• If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately).
• The diagram and the fuse amperage shown above are in the case when IVA-W200 is used individually.
• If the switched power (ignition) lead of the IVA-W200 is connected directly to the positive (+) post of the vehicle's battery, the IVA-W200 draws
some current (several hundred milliamperes) even when its switch is placed in the OFF position and the battery may be discharged.
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various
noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
This unit
Bracket keys
(Included)
Pinch
Connector
(sold separately)
Pinch
Connector
(sold separately)
IGNITION
(Red)
BATTERY
(Yellow)
< JAPANESE CAR >
Take the face plate off, and secure the ground lead of the unit to
a clean metal spot using a screw (*) already attached to the
car's chassis.
Attach the Original Mounting Bracket to each side of the IVA-
W200, using the screws supplied with IVA-W200.
Ground Lead
*
Chassis
Foot brake lamp
Foot brake lead
Parking brake lamp
Parking brake lead
Screws (M5 × 8)
(Included)
Mounting
Bracket
Face Plate (Included)
Foot brake switch
Battery
Parking brake switch
FUSE (5A)
SPST SW (Optional) (Optional)
FUSE (20A)
(Optional)
Chassis
Battery
69
-EN