Kenmore 795.7414 Manual De Uso Y Cuidado página 47

ICE & WATER
Problem
Water is not New installation or water line recently connected.
dispensing.
•
The dispenser panel is locked.
•
The dispenser is not set for water dispensing.
•
Refrigerator or freezer doors are not closed properly.
•
•
Tubing connecting refrigerator to house supply valve is kinked.
•
The house water supply is not connected, the valve is not turned on fully, or the valve is clogged.
•
Water is dispensing
slowly.
•
•
Low house water supply pressure.
•
Dispenser is Refrigerator was recently installed.
dispensing warm
•
water.
The water dispenser has been used recently and the storage tank was exhausted.
•
Dispenser has not been used for several hours.
•
Refrigerator is connected to the hot water supply.
•
WARNING: Connecting the refrigerator to a hot water line may damage the icemaker.
contaminants from the system. Do not dispense the entire 2.5 gallon amount continuously.
Depress and release the dispenser pad for cycles of 30 seconds ON and 60 seconds OFF.
Press and hold the Control Lock button for three seconds to unlock the control panel and
dispenser.
The dispenser can be set for ice or water. Make certain that the control panel is set for the
proper operation. Press the Ice / Water button on the control panel to dispense water.
Water will not dispense if any of the refrigerator doors are left open.
the entire 2.5 gallon amount continuously. Depress and release the dispenser pad for
cycles of 30 seconds ON and 60 seconds OFF.
The tubing can kink when the refrigerator is moved during installation or cleaning.
to prevent future kinks.
the problem persists, it may be necessary to contact a plumber.
Approximately every six months.
When the water dispenser output decreases.
When the ice cubes are smaller than normal.
amount and result in icemaker issues. If the problem persists, it may be necessary to
contact a plumber.
necessary to contact a plumber.
Allow 24 hours after installation for the water storage tank to cool completely.
approximately 20 to 30 oz.
Make sure that the refrigerator is connected to a cold water pipe.
Possible Cause & Solution
47
TROUBLESHOOTING GUIDE