Kenmore 795.7414 Manual De Uso Y Cuidado página 12

REFRIGERATOR INSTALLATION
NOTE: Removing the doors is the recommended procedure when it is necessary to move the refrigerator through a
narrow opening. If it is necessary to remove the handles, follow the directions below.
HOW TO REMOVE FREEZER DOOR HANDLE
NOTE: Handle appearance may vary from the illustrations
on this page.
Removing Freezer Drawer Handle
Loosen the set screws located on the lower side of the
handle with a 3/32 in. (2.5 mm) Allen wrench and remove
the handle.
NOTE: If the handle mounting fasteners need to be
tightened or removed, use a ¼ in. (6.4 mm) Allen
wrench.
HOW TO REPLACE FREEZER DOOR HANDLE
NOTE: Handle appearance may vary from the illustrations
on this page.
Replacing Freezer Drawer Handle
Place the handle on the door by fitting the handle
footprints over the mounting fasteners and tightening
the set screws with a 3/32 in. (2.5 mm) Allen wrench.
NOTE: If the handle mounting fasteners need to be
tightened or replaced, use a ¼ in. (6.4 mm) Allen
wrench.
WARNING
When assembling or disassembling the handles:
• Grasp the handle firmly to ensure it will not drop or
cause injury.
• Prevent the handle from swinging toward nearby
people or animals.
• Insert the bracket hole of the handle into the
stopper bolt of the door exactly, then assemble the
set screws to fix the handle in place.
• Check for any gap between the door and handle
after the handle is fixed in place.
12