Kohler K-8034 Guia De Instalacion página 8

6-3/4" (17.2 cm)
Soldering Template
Clamp each tee
to template
during soldering.
2. Install the Supply Piping – Single Supply
Route the water supply lines.
Use the provided soldering template to construct a pressure
balancing loop; this will ensure proper alignment with the
product.
Assemble the pressure balancing loop with a tee positioned over
each of the four raised locations on the soldering template.
Solder the assembly while it is still attached to the soldering
template.
Remove the pressure balancing loop assembly from the soldering
template.
Connect the pressure balancing loop to the water supply.
Do not strap the pipes.
Temporarily install a nipple to each tee. Do not use any sealant.
1078520-2-C
9-5/8"
Pressure
(24.4 cm) D.
Balancing
Loop
6-3/4"
(17.2 cm)
1/2" NPT Nipple
Pressure
Balancing Loop
8
Soldering
Template
Kohler Co.