Vacuum Function For The Blender Container - CASO DESIGN B300 VacuServe Manual Del Usuario

Turn the knob to level 1 or 2 until the desired
consistency is achieved.
Function P (Pulse).
1. Turn the knob to Position P until the
desired consistency is achieved. The appliance
runs for as long as you keep the knob in
Position P.
Remove the blended foods.
► Do not let the device run idle and do not over
fill it. The motor could be damaged.
► Do not operate the device longer than 15
seconds and then pause for 60 seconds.
► Fill the blender attachment up to maximum level of the max marking.
► The appliance is equipped with overheating protection. If the appliance has been
operated for too long or has been operated when overfilled, the appliance switches itself
off. Pull the mains plug and allow the appliance to cool down for at least half an hour.
You can then operate the appliance as usual.
► Pull the mains plug following use.
► Clean the accessories directly following use. To this end turn the blade base
anticlockwise and remove it from the jug /mix drinking bottle /crusher attachment

14.5 Vacuum function for the blender container

Turn the lid tight onto the blender bottle. To vacuum blender bottles, open only the small
lid above the vacuum valve. The large lid must remain tightly sealed.
Or: The lid must snap into place on the jug and the middle part must be inserted in the lid
of the jug.
Please note
43