Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
Electrical Requirements
(Electric Dryers)
(120/240 Volt, 60 Hertz, 3-Wire Installation)
(120/208 Volt, 60 Hertz, 3-Wire Installation)
NOTE: The wiring diagram is located behind the
control panel, inside the control cabinet.
WARNING
To reduce the risk of fire, electric shock or
personal injury, all wiring and grounding
MUST conform with the latest edition of
the National Electrical Code ANSI/NFPA
70 or the Canadian Electrical Code, CSA
C22.1, and such local regulations as
might apply. It is the customer's
responsibility to have the wiring and
fuses checked by a qualified electrician to
make sure the laundry room has adequate
electrical power to operate the dryer.
Grounding and Wiring Instructions
Each dryer must be connected to a grounded
G
metal, permanent wiring system; or an
equipment-grounding conductor must be run
with the circuit conductors and connected to the
equipment-grounding terminal or lead on each
dryer.
22
W035
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Each dryer has its own terminal block that must
G
be connected to a separate branch, 60 Hertz,
single phase circuit, AC (alternating current)
circuit, fused at 30 Amperes (the circuit must be
fused on both sides of the line). ELECTRICAL
SERVICE FOR THE DRYER UNIT
SHOULD BE OF MAXIMUM RATED
VOLTAGE LISTED ON THE NAMEPLATE.
DO NOT CONNECT DRYER TO 110, 115,
OR 120 VOLT CIRCUIT. Heating elements are
available for field installation in dryer units
which are to be connected to electrical service of
different voltage than that listed on nameplate,
such as 208 Volt.
If branch circuit to dryer unit is 15 feet (4.5 m) or
G
less in length, use U.L. (Underwriters
Laboratories) listed No. 10 A.W.G. wire (copper
wire only), or as required by local codes. If over
15 feet (4.5 m), use U.L. listed No. 8 A.W.G.
wire (copper wire only), or as required by local
codes. Allow sufficient slack in wiring so dryer
can be moved from its normal location when
necessary.
The power cord (pigtail) connection between
G
wall receptacle and dryer unit terminal block is
NOT supplied with dryer unit. Type of pigtail
and gauge of wire must conform to local codes
and with instructions mentioned on the following
pages.
The method of wiring the dryer unit is optional and
subject to local code requirements. Refer to Figure 13.
510975
Capítulos
Tabla de contenido
