Troubleshooting - Shop-Vac SM12 Serie Manual Del Usuario

3. The hose may be stored in the hose holder. To do this place one end of the hose
between the hose holder posts and the tank cover. Wrap the hose around the tank
cover keeping the hose tucked between the posts and the cover.
4. The accessories may be stored in the tool storage, that came with
your vacuum. Some models come with a rear tool rack or basket.
Other models come with slots in the hose holder and in the back of
the tank cover. The vacuum should be stored indoors.
PROBLEM
Loss of suction or
cleaner runs hot
Dust discharging
from tank cover
Mist discharging
from tank cover
Will not start
WARNING
OR BROKEN, EXPOSING THE MOTOR OR ANY OTHER ELECTRICAL COMPONENTS, OPERATION SHOULD
BE DISCONTINUED IMMEDIATELY TO AVOID PERSONAL INJURY OR FURTHER DAMAGE TO
THE VACUUM. REPAIRS SHOULD BE MADE BEFORE REUSING THE VACUUM.
PAGE 12
STORAGE (CONT'D.)

TROUBLESHOOTING

POSSIBLE CAUSES
1. Clogged filter
2. Full tank
3. Air Leak
4. Hole in hose
5. Obstruction in hose or
accessory
1. Filter not properly
installed
2. Filter damaged
3. Dust too fine for filter
1. Saturated filter
2. Full tank
1. Power cord not plugged into
outlet
2. No power at the outlet
3. Defective switch or motor
–
IF ANY OF THE MOTOR HOUSING PARTS SHOULD BECOME DETACHED
SOLUTION
1. Clean or replace filter
2. Empty tank
3. Tighten hose and accessory
connections
4. Replace hose
5. Remove obstruction
1. Properly install filter
2. Replace filter
3. Add a high efficiency disposable
filter bag
1. Allow filter to dry or replace with
dry filter
2. Empty Tank
1. Plug cord into outlet
2. Plug cord into another outlet
3. Contact Shop-Vac ®
customer service