Optional Oximeter Connection - DeVilbiss Healthcare SmartLink DV5M Guía De Instrucciones

EN
1. Locate the primary data connector on the back of the
SmartLink Module. Align and engage the primary data
connector into the circular DIN connector on the back of the
CPAP . At the same time, align and engage the three locking
tabs on the module with the three locking recesses on the
back surface of the CPAP Figure 1.
2. Firmly press the module onto the back of the CPAP until the
module is fully secured and locked into position Figure 2. An
audible click may be heard confirming that the module is
properly attached to the CPAP . Visually confirm that there is
not a gap between the module and the CPAP .
Removal From The CPAP
To remove the module from the CPAP:
1. Fully depress the release button on the side of the module.
2. Pull the module straight back and away from the CPAP .
CAUTION- Do not pull up on the module as this may
damage the data connector.

Optional Oximeter Connection

The SmartLink Module provides oximeter connection capability to
allow an approved oximeter to be used with the CPAP/module
system. Connect the oximeter cable into the oximeter connection
port located on the side of the module. If you are using an
oximeter, please refer to the assembly and operation instructions that came with the
oximeter Figure 3.
You can see your oximeter readings by using the SmartLink menu (see SmartLink Menu
Structure) at any time.
Message shown when the oximeter is first connected and logging
starts. This message will remain on display for five seconds. The
pulse oximeter menu (SpO
Message shown when the oximeter is removed. This message
will remain on display for five seconds. Multiple notifications
will occur until logging stops.
6 A-DV5M-1
/PR) will then be displayed.
2
seT up / oxIMeTer
Oximeter
Connected
Oximeter
Removed
1
2
3